Campagnolo 10v

Hola,

He visto unas manetas de cambio campagnolo : Veloce Power Shift 2x10 Ergopower.

Están muy bien de precio... Pero cuando veo las bielas campagnolo... Se me van de presupuesto...

Alguien sabe qué platos y bielas son compatibles con campagnolo 10?

Supongo que mis bielas shimano ultegra 600 para 8 v. no servirán?

Gracias!

 

No tendras problemas en poner bielas Campagnolo o de otro fabricante, antes de gastarte el dinero en ello mira que que tus bielas actuales funcionen, que quizas no tenga problemas otra cosa es si tienes los platos desgastados quizas colocando unos de 9-10 bastaria

Traducete este texto de "Sheldonbrown" viene a decir que los fabricantes dicen una cosa pero en la practica no se suele cumplir

Si no quieres gastarte dinero, yo probaria con tus actuales bielas

Chainrings/Cranks
Old Chainrings, New Chains
There is a lot of confusion about the compatibility of narrow 9- and 10-speed chains with older cranksets. Shimano says you should replace the inner chainring(s) with specially designated 9- or 10-speed ones, but then they're all too eager to sell you stuff, whether you need it or not.
These chainrings have the teeth slightly farther to the right than the older chainrings to work a little better with the narrower chains. There is no difference whatever in the crank spiders.

The manufacturers also are concerned about clueless users. The worst-case scenario is that you will be riding along with the bike in its highest gear (large front, small rear) and then for some bizarre reason shift down in front before downshifting in the back. (There is no shift pattern in which it is reasonable to shift in this sequence.) [Not with a 9- or 10-speed cassette, to be sure -- John Allen] If you do shift this way, there's a small chance that the chain might "skate" over the edges of the teeth for maybe half a turn.

In practice this "problem" almost never materializes. Many, many cyclists are using 9- and 10-speed chains with older cranksets and having no problems whatever.

New Chainrings, Old Chains
Going the other direction, using wider chains with chainrings intended for narrower chains is not generally a major problem if there's only a one- or two- generation difference. The only problem you might run into is that the chain will be more liable to rub on the inside of the bigger chainrings in the small/small crossover gears, gears you shouldn't be using in any case.